VEW-A Automated Wash Water Recycling System
Treat and discharge, or full recycle

VEW-A Automated Wash Water Recycling Systems
The VEW-A automated wash water recycling systems are designed for the treatment of wastewater generated from wash racks and pressure washers used in vehicle and equipment washing facilities. VEWs can be used as a single pass and discharge system or as a recycle system depending on the project needs. The VEWs are designed to remove oils, fuels, suspended solids and other contaminants.
Sub-systems
- Oil water separator
- Solids filtration
- Effluent pump-out system
- Zeomaxx polishing filter
- Master Control Panel (MCP) automatic controls
Treat and discharge, or full recycle
The VEW-A can be used as a stand-alone treat and discharge to sewer design, or, combined with the other VEW modules, it becomes a full recycle/reuse system. The other modules needed for full recycle are:
- IFS Influent Feed System
- PSM Pressurized Supply Module
- EnBio biological treatment system and Superaerator aerating system
- Sludge handling filter
- Washpad & collection sump
Models
| Model | Flow rate (GPM) | Operating weight (lb) | Voltage (V/ph/Hz) |
|---|---|---|---|
| VEW-2-A | 5 | 805 | 115/1/60 |
| VEW-4-A | 10 | 2,000 | 115/1/60 |
| VEW-8-A | 25 | 4,020 | 115/1/60 |
| VEW-12-A | 35 | 4,800 | 230/3/60 |
| VEW-16-A | 50 | 6,200 | 230/3/60 |
Larger systems can be provided for flow rates from 50 to 300 GPM. Options include a dual sludge filter (SF-2) and an automatic sludge valve (ASV). Customization and modifications to fit your project are offered, and any of the technologies in our family of products can be combined to create the right solution for your application.
Performance
Typical performance is 10 and 5 ppm or less, 30 micron oil droplet (performance depends on model). Contaminants removed include motor oils, fuels (vehicle/jet), fuel oils, hydraulic fluids, immiscible machining oils, lube oil, transmission fluid, bunker C, DNAPLs, LNAPLs, crude, air compressor lube and other hydrocarbon based derivatives (BTEX etc.), and all filterable solids 25 micron and greater. Model sizing is based on the oil/fuel specific gravity, the droplet size removal desired and other parameters of the waste stream.
Request a quote: VEW-A Automated Wash Water Recycling System
Tell us your flow rate and what is in the water. Our engineers size every system for your facility and reply with questions or a recommendation. Quote requests go straight to our sales team.
Need help choosing or sizing a VEW-A?
Our engineers size and configure every system for your flow rate, wastewater and site. Contact us for a consultation, pilot testing or a custom quote.


